|
FINISH IS TOO STICKY OR TACKY |
|
CAUSE |
SOLUTION |
|
Not enough dry time between coats. |
Under normal conditions, finishes dry in 30-45 High humidity will extend these dry times. |
|
|
|
Restorer not properly diluted or applied too frequently. |
Follow label instructions. Overuse can leave .sticky residue. |
|
|
|
Restorer/maintainer not burnished soon enough after application |
When dry, restorer/maintainer will continue to soften finish if not burnished. |
|
|
|
Floor not properly rinsed before application of finish. |
Thoroughly rinse and neutralize floor after stripping. Use neutral cleaner in proper dilution. |
|
|
|
Improper use of disinfectants. |
Measure carefully and follow label directions. |
|
|
|
Separation of finish |
Finish may have been exposed to prolonged heat or cold. Shake or stir before using. |
|
|
|
Alkaline or detergent contaminated tile. |
Make sure to rinse floor until pick-up water remains clear. When recoating, make sure no cleaner residue remains on floor - rinse with clean water to prevent problems. |
|
|
|
Finish is applied too thick. |
Apply thin coats and allow each coat to dry before applying the next coat. |
|
|
|
FINISH SWIRLS OR SCRATCHES |
|
CAUSE |
SOLUTION |
|
Pad too aggressive |
Use the recommended pad for a particular task, whether it be burnishing or cleaning. |
|
|
|
Pad is dirty or has build-up. |
Clean with a wire brush or put pad in deep sink and spray off the build-up. Hang up to dry. |
